Applying Custom Car Decals
Lay decal, FACE UP on a smooth hard surface. Squeegee the surface to insure good contact between the pre-mask and the vinyl beneath it. | Lay decal flat, FACE DOWN. Slowly remove backing paper from the pre-mask, pulling straight back and flat as shown (not at an angle). | Apply pressure-sensitive vinyl to prepared surface, then squeegee pre-mask surface using overlapping strokes. | To expose product, pull pre-masking away at an angle using a continuous motion. If bubbles occur in the letters, simply prick with a needle and smooth. Do not use a knife or razor. |
Pro-Cut Guidelines
Square Inches:
To determine Square Inches, multiply the Total Width x Total Height of image.
Example See Above: 4.5" x 1.375" = 6.1875"
Car Dealer Decal Specifications:
- All Text must be at least .25 inches tall.
- The space between characters and elements must be at least .045 inches.
- Main strokes, line weights or art elements should be a minimum of .0625 inches.
- Pro-cuts should be measured according to the active material area being used.
- An additional carrier for the material will be applied automatically for the process.
Picks are the areas of the letters or graphics that must be pulled out after cutting. Additional costs are applied to orders over 14 picks per decal.
For pricing of car dealer decals: